Charging The Battery, Leds; Activating And Deactivating Bluetooth® Radio Interface; Assembling Weeder - Stihl Rga 140 Gebrauchsanleitung

English
5.2 Connecting a battery with Blue‐
tooth radio interface with the
®
STIHL connected app
► Activate the Bluetooth
mobile device.
► Activating the Bluetooth
the battery, 7.1.
► Download the STIHL connected app to the
mobile device from the App Store and create
an account.
► Open and sign in to the STIHL connected app.
► Add the battery in the STIHL connected app
and follow the instructions on the screen.
For contacts and other information, please visit
https://support.stihl.com or see the STIHL con‐
nected app.
The STIHL connected app is available interna‐
tionally.
6

Charging the Battery, LEDs

6.1 Charging the battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimal performance, note the rec‐
ommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
► Recharge the battery as described in the User
Manual for STIHL AL 101, 301, 301-4, 501
chargers.
6.2 Displaying the charge level
1
► Press the button (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on the Battery
The LEDs can indicate the state of charge of the
battery or any faults. The LEDs can be steady
green, steady red or flashing.
34
®
radio interface on the
®
radio interface on
21.5. The
80-100%
60-80%
40-60%
20-40%
0-20%
6 Charging the Battery, LEDs
If the LEDs are steady or flashing green, this
indicates the state of charge of the battery.
► If the LEDs glow or flash red: Troubleshooting,
20.1.
There is a fault in the weeder or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1 Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2 Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
7.3 Reset battery to the factory set‐
ting via a Bluetooth
face (AP 200.0 S, 300 S,
300.0 S, 500.0 S only)
Resetting the battery to the factory setting means
that all user-specific data will be deleted.
► Press the pushbutton four (4) times in quick
succession and keep it pressed on the fourth
time until the "BLUETOOTH
the symbol flashes blue.
► Then release the pushbutton immediately.
► Connect the battery to the STIHL connected
app and check whether all user-specific data
has been deleted.
8

Assembling Weeder

8.1 Mounting the Bike Handle
► Switch off the weeder and remove the battery.
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
radio inter‐
®
®
" LED next to
0458-845-9802-A