Charging The Battery, Leds; Activating And Deactivating Bluetooth® Radio Interface; Assembling The Trimmer - Stihl FSA 90 Gebrauchsanleitung

English
► Adjust the handle,
► Check the controls,
► If you cannot carry out this work: Do not use
your brushcutter and contact your STIHL
authorized dealer for assistance.
5.2 Connecting a battery with Blue‐
tooth radio interface with the
®
STIHL connected app
► Activate the Bluetooth
mobile device.
► Activating the Bluetooth
the battery, 7.1.
► Download the STIHL connected app to the
mobile device from the App Store and create
an account.
► Open and sign in to the STIHL connected app.
► Add the battery in the STIHL connected app
and follow the instructions on the screen.
For contacts and other information, please visit
https://support.stihl.com or see the STIHL con‐
nected app.
The STIHL connected app is available interna‐
tionally.
6

Charging the Battery, LEDs

6.1 Charging the Battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, observe the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
► Recharge the battery as described in the User
Manual for the STIHL AL 101, 301, 301-4, 500
chargers.
6.2 Displaying the charge level
1
► Press the button (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
36
9.2.
12.1.
®
radio interface on the
®
radio interface on
21.4. The
80-100%
60-80%
40-60%
20-40%
0-20%
6 Charging the Battery, LEDs
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
20.
Malfunction in trimmer or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
8

Assembling the Trimmer

8.1 Mounting the Handle
FSA 90
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
1
2
4
5
► Remove the wing screw (1).
► Remove the upper clamp molding (2).
Radio
®
®
radio interface:
symbol
®
radio interface:
symbol
3
6
3
0458-709-9821-D
®
8
7