Leds On Battery; Activating And Deactivating Bluetooth® Radio Interface; Assembling The Trimmer; Mounting The Handle - Stihl FSA 90 Gebrauchsanleitung

English
► If the LED on the right flashes green: Charge
the battery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
20.
Malfunction in trimmer or battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery is equipped with a Bluetooth
radio interface: press the button and hold it
depressed for about 3 seconds.
The "BLUETOOTH
bol lights up blue for about 3 seconds. The
®
Bluetooth radio interface on the battery is
activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery is equipped with a Bluetooth
radio interface: press the button and hold it
depressed for about 3 seconds.
The "BLUETOOTH
bol flashes blue for six times. The Blue‐
®
tooth radio interface on the battery is deacti‐
vated.
8

Assembling the Trimmer

8.1

Mounting the Handle

FSA 90
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
1
2
4
5
36
Radio
®
®
" LED next to the sym‐
®
" LED next to the sym‐
3
6
3
7 Activating and Deactivating Bluetooth® Radio Interface
► Remove the wing screw (1).
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp
molding (4).
► Fit the upper clamp molding (2).
► Insert the wing screw (1).
► Swing the handlebar (3) up.
► Tighten down the wing screw (1).
► Remove the screw (6).
► Position the control handle (7) on the handle‐
bar (3), trigger facing the gear housing, and
line up the hole in the control handle with the
hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6) firmly.
®
► Position the throttle cable retainer (10) and the
throttle cable (9) on the shaft.
Do not kink the throttle cable or lay it in tight
®
radii – make sure the throttle trigger moves
freely.
► Squeeze the throttle cable retainer (10).
®
The throttle cable retainer (10) engages in
position with an audible click.
The bike handle can be lefton the shaft.
FSA 90 R
► Switch off the brushcutter, push the retaining
latch to position
8
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
7
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
9
10
and remove the battery.
1
2
3
4
5
6
7
0458-709-9921-C