Activating And Deactivating Bluetooth® Radio Interface; Assembling The Trimmer - Stihl Fsa 110.0 R Gebrauchsanleitung

English
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
8

Assembling the Trimmer

8.1 Attaching the deflector
► Switch off the brushcutter and remove the bat‐
tery.
1
2
3
The line limiting blade (2) has already been
installed in the deflector (1) and must not be
removed.
► Fit the deflector (1) on the housing (3) and line
up the holes.
► Insert screws (4) and tighten them.
The deflector (1) must not be removed.
8.2 Attaching the loop handle
► Switch off the brushcutter and remove the bat‐
tery.
32
7 Activating and Deactivating Bluetooth® Radio Interface
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
4
1
9
4
8
7
► Insert the pin (8) into the opening in the quick
release clamp (5).
Align the pin (8) so that the notch of the pin is
at the bottom.
► Place the clamp (3) in the loop handle so that
the holes are aligned.
► Place the loop handle (2) with clamp (3) on the
shaft (9).
► Insert the long screw (7) through the holes in
the pin and quick release clamp (5).
► Press the clamp (4) against the shaft so that
the holes are aligned.
► Insert the short screw (6) through the holes.
► Insert the long screw (7) through the holes.
► Screw on the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) is properly adjusted if it can
no longer be moved.
► If the loop handle (2) can be moved:
► Open the quick release clamp (5).
► Tighten the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
► If the quick release clamp (5) cannot be
closed:
► Open the quick release clamp (5).
► Loosen the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) can no longer be
moved.
8.3 Mounting and Removing the
Mowing Head
8.3.1 Attaching the mowing head
► Switch off the brushcutter and remove the bat‐
tery.
2
3
5
6
0458-064-9601-A