Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- Switch on the equipment only whenit is safely installed on the work
surface.
m ATTENTION
Keep your hands away from the grinding disc and grinding belt
when the device is in operation. Injury hazard!
9.1 Switching on and off
• To switch on, press the "I" on switch (8) and the device starts up.
• To switch off, press the "0" off switch (8) and the device switches off.
After switch on the device, wait until the device has reached its max.
speed. Only then must you start with the grinding.
m ATTENTION
The disk will continue to run after the equipment is switched off.
There is a risk of injury.
Test run:
Before starting work and after each change of grinding disk, carry out
a test run of at least 60 seconds with no load. Switch off the equipment
immediately if the disc runs lumpy, substantial vibrations occur, or ab-
normal noises are generated.
10. Working instructions
10.1 Grinding with the grinding disc
m ATTENTION
Fold down the spark protection (1) when grinding in order to avoid
injury from sparks.
NOTE: The arrow on the protective hood (7) shows the direction of rota-
tion of the grinding disc.
• Place the workpiece on the workpiece support (4) and slowly bring it
to its desired angle on the grinding disc (3).
44 | GB
www.scheppach.com
Werbung
