• Move the workpiece slightly from side to side in order to achieve an
optimal grinding result. This way, the grinding disc is worn uniformly.
Occasionally, allow the workpiece to cool down.
10.2 Tape loops
NOTE: The arrow on the protective hood (16) shows the direction of
rotation of the grinding belt.
• Firmly hold the workpiece, do not exert any strong force.
• Move the workpiece slightly from side to side in order to avoid a
one-sided wear of the grinding belt.
• Always grind the pieces of wood in the direction of the wood grain in
order to avoid chipping.
10.3 Change grinding belt (Fig. 6)
• Loosen the 2 fixing screws (11) and hang out the grinding belt cover
(12).
• Press the clamping lever (18) downwards and detract the grinding belt
(19).
• Place the new grinding belt (19) in the centre on the upper (10a) and
lower (10b) rollers.
• Push the clamping lever grinding belt (18) and mount the grinding belt
cover (12).
10.4 Set the tape run
• The tape run accuracy is set by turning the adjusting screw for belt
run (12).
• Check the tape run by manually turning the grinding belt.
10.5 Change grinding disc (Fig. 7)
Information on replacement:
- Never operate the device without protective equipment.
- Ensure that the rotation speed stated on the grinding disc (3) is the
same or higher than the nominal rotation speed of the device.
- Ensure that the grinding disc dimensions match those of the device.
www.scheppach.com
GB | 45