Parkside Performance 458809 2401 Originalbetriebsanleitung Seite 28

GB MT
• Switch the power tool off im-
mediately if the application tool
becomes blocked. Be prepared
for high torque reactions which
cause kickback. The application
tool becomes blocked when it be-
comes jammed in the workpiece
or when the power tool becomes
overloaded.
• Always wait until the power tool
has come to a complete stop be-
fore placing it down. The applica-
tion tool can jam and cause you to
lose control of the power tool.
• Hold the power tool securely.
When tightening and loosening
screws be prepared for temporarily
high torque reactions.
• Use suitable detectors to de-
termine if there are hidden sup-
ply lines or contact the local util-
ity company for assistance. Con-
tact with electric cables can cause
fire and electric shock. Damaging
gas lines can lead to explosion.
Breaking water pipes causes prop-
erty damage.
• Only use accessories recom-
mended by PARKSIDE. Unsuit-
able accessories may cause elec-
tric shock or fire.
Residual risks
There will always be residual risks
even if you operate this power tool
according to the instructions. The fol-
lowing hazards may occur in connec-
tion with the type and design of this
power tool:
• Hearing damage if suitable ear pro-
tection is not worn.
• Health injuries resulting from the
effect of hand/arm vibration in the
event that the tool is used over a
longer period of time or is not used
and maintained properly.
• Cutting injuries
28
WARNING! Danger due to elec-
tromagnetic field generated while the
tool is in operation. Under certain cir-
cumstances, this field may negat-
ively affect active or passive med-
ical implants. In order to reduce the
danger of serious or fatal injuries, we
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the
implant before operating the tool.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.
Control elements
Familiarise yourself with the operating
elements before using the device for
the first time.
• Direction of rotation switch (4)
Fig. A
NOTICE! Only operate the direction
of rotation switch when the tool
has stopped!
The arrow on the direction switch
(4) indicates the working direction.
• Screw in screw, drill
• Centre Switch lock
• Unscrew screw
• Torque adjustment ring (2)
Setting of the maximum torque
for screwing at which the slipping
clutch is disengaged.
NOTICE! Only operate the torque
adjustment ring when the device is
at a standstill!
• 1 lowest torque
• 20 highest torque
To be safe, start with a low
torque when screwing. Increase