Scheppach HG35 Originalbetriebsanleitung Seite 25

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise your-
self with your device and to use it for its intended purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1)
1. Protective glass
2. Polishing wheel *
3. Lock nut
4. Connection thread
5. Flexible shaft
6. Black sleeve
7. Collet holder
8. Speed control
9. On/off switch
10. Knurled screw
11. Workpiece support
12. Grinding disc *
13. 5 cutters
14. 4 cleaning brushes
15. 3 brass brushes
16. 10 grinding pencils
17. 5 grinding belts Ø15 mm
18. Work arbor for grinding belts Ø15 mm
19. 5 grinding belts Ø9 mm
20. Work arbor for grinding belts Ø9 mm
21. 3 collets (2.0 - 2.4 - 3.2 mm *)
22. Dressing stone
23. Combination key
24. Work arbor for polishing felts
25. 5 polishing felts Ø25 mm
26. 5 polishing felts Ø13 mm
27. Polishing compound
28. 40 cutting wheels Ø24 mm
29. 12 cutting wheels Ø32.5 mm
30. Work arbor for cutting wheels
31. Protective glass fixing screw
32. Spark protection
33. Spark protection fixing screw
34. Shaft
35. Centring flange
36. Spring washer
37. Union nut
38. Attachment for the flexible shaft
38a. Locking pin
39. Fixing screw
40. Protective cover
41. Holes
* pre-assembled
www.scheppach.com GB | 25