Establishing A Wi-Fi Connection - Syr All-In-One+ Connect Anleitung Zur Montage, Inbetriebnahme, Bedienung Und Wartung

Set a project name, enter your user data and confi rm your information. Then choose a
user name and a password of at least eight characters.
Read the privacy terms and accept them. Click on "Register".
Please note that remote access to your All-in-One+ Connect via Internet
is only possible if there is an active Internet connection.
Do not switch off your router if you want to control your All-in-One+
Connect Leakage Protection via the Internet and/or the SYR App.
The All-in-One+ Connect has an AccessPoint (AP), that creates its own domestic Wi-Fi network. The SYR App joins this network. You may
now connect your All-in-One+ Connect to the wireless network of your choice.

8.2. Establishing a Wi-Fi connection

Activate the AccessPoint of the All-in-One + Connect so that the SYR Appcan connect to
the device. Press the button underneath the display for 10 seconds.
Once connected, the SYR App wants to join the Wi-Fi network of the All-in-One + Connect.
Click on "Join".
Then assign the desired wireless network from the list to the All-in-One + Connect.
Enter the password of the selected wireless network, click on OK and save it.
The corresponding confi rmation is displayed.
Go back to the list of devices in your project. A green dot will indicate that the
All-in-One + Connect is connected to your Wi-Fi network.
Please make sure that you are close to the device so that a connection can
be established.
If the system fails to connect, check whether the AccessPoint mode of the
All-in-One+ Connect is activated. The AccessPoint switches off after three
minutes and must be reactivated, if necessary.
..................
21