syr All-in-One+ Connect Anleitung Zur Montage, Inbetriebnahme, Bedienung Und Wartung Seite 60

Now open the isolating valve of the connection fl ange again.
Start the "Erstbefüllung" (initial fi lling) by pulling the slider to the right.
The initial fi lling starts.
The All-in-One+ Connect fi lls the system until the set target pressure has been reached. It then switches to "automatischer Nachfüllbetrieb"
(automatic refi ll mode).
This completes the initial commissioning!
The device is ready for operation!
Note: Please follow the instructions in chapter 13.3 - 13.5 (page 32 – 35) if replacing the granules is
necessary for the initial fi lling!
Design aids according to VDI 2035/I
Total heating capacity
< 50 kW
50 - 200 kW
200 - 600 kW
> 600 kW
Type of system
Tubular and steel radiators
Cast iron radiators
Underfl oor heating (approx. 60 W/m
Steel panel radiators
Convectors
Systems with buffer storage
< 20l / kW
16,8 °dH for recirculation heaters
11.2 °dH
8.4 °dH
< 0.11 °dH
)
2
20l / kW & 50l / kW
11.2 °dH
8.4 °dH
0.11 °dH
< 0.11 °dH
Filling volume in litres / kW ca.
> 50l / kW
< 0.11 °dH
< 0.11 °dH
< 0.11 °dH
< 0.11 °dH
35
25
20
15
10
> 20
19