Assembly Of The Connection Set With Adapter - Syr All-In-One+ Connect Anleitung Zur Montage, Inbetriebnahme, Bedienung Und Wartung

Connection for 14l + 30l Connection for 2,5l - 7l
cartridge
Attention!
Potential material damage due to improper handling!
•
The cartridges must be secured so that they cannot fall over during fi lling.
7.4.2 Assembly of the connection set with adapter (accessories for heating water conditioning)
The connection set is available as an optional accessory for heating water treatment (order number 3228.00.004), install it according to the
following description.
•
Guide the union nuts of the pre-assembled adapter over
the two connection pieces of the All-in-One+ Connect.
Make sure that the following conditions are met:
•
The front connection piece (operating side) of the
All-in-One+ Connect must be connected to the union nut
of the "IN-marking" on the connection set.
The rear connection piece (pipeline side) of the
All-in-One+ Connect must be connected to the union nut
of the "OUT-marking" on the connection set [image 1].
•
Tighten the union nuts. When the adapter is securely
mounted, screw on the selected cartridge (2.5 litres or
4 litres) [image 2].
(back side) IN
OUT
strainer
Remove the strainer from the connection set (in connection
cover) when using a 14 or 30 l cartridge.
These cartridges are equipped with a segment ring fi tting
with a strainer, so there is no need for the strainer in the
connection set.
[image 1]
Out (Front side)
IN
[image 2]
15