VEVOR RP8623S Bedienungsanleitung Seite 30

4.Check that the Spray/Prime Switch (F) is in the Prime Position.
5. Set the Pressure Control Knob (D) to the Prime/Clean position.
6. Plug the sprayer into a grounded outlet and turn the power ON / OFF Switch (B)
to the ON position.
7. The sprayer will start pumping water or flushing solvent. Air and storage oil will
be purged from the system. Allow the fluids to continue being discharged from the
Primer Output Tube (H) for 30 to 60 seconds, then turn the power ON / OFF
- 28 -