Residual Risks; Preparation; Control Elements; Attaching And Removing The Saw Blade - Parkside Performance Pphksa 40-Li A1 Originalbetriebsanleitung

GB MT

Residual risks

There will always be residual risks
even if you operate this device ac-
cording to the instructions. The fol-
lowing hazards may occur in connec-
tion with the type and design of this
device:
• Eye damage if no suitable eye pro-
tection is worn.
• Hearing damage if suitable ear pro-
tection is not worn.
• Health injuries resulting from the
effect of hand/arm vibration in the
event that the tool is used over a
longer period of time or is not used
and maintained properly.
• Cutting injuries
WARNING! Danger due to elec-
tromagnetic field generated while the
tool is in operation. Under certain cir-
cumstances, this field may negat-
ively affect active or passive med-
ical implants. In order to reduce the
danger of serious or fatal injuries, we
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the
implant before operating the tool.

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.

Control elements

Familiarise yourself with the operating
elements before using the device for
the first time.
• Switch lock (1)
• Locks the on/off switch against
unintentional operation.
• Unlocking: Press
• On/Off switch (2)
• Switching on: Press
36
• Switching off: Release
• Speed button (33)
• Switch speed level
1 ≙ lowest speed level
6 ≙ highest speed level
• Guide notch (44)
• Helps to guide the tool straight.
• Only available for the following
cutting angles: 0°, 45°
Attaching and removing the
saw blade
CAUTION! Risk of injury
when touching the saw blade.
Wear protective gloves when
handling the saw blade.
Requirements
• Never use a grinding disc. The
speed and safety devices of a
circular saw are not suitable for
grinding discs.
• Select a suitable saw blade ac-
cording to the material to be sawn.
• Saw blades intended for cutting
wood or similar materials must
comply with EN 847-1.
• Only use saw blades with diamet-
ers corresponding to the labelling
on the saw.
• Only use saw blades with a max-
imum diameter: 190 mm
• Only use saw blades with a speed
designation that meets the spe-
cified speed for your appliance or
higher.
• Minimum speed designation for
saw blade: 6000 min⁻¹
• The saw blade has no visible
cracks. Circular saw blades with
cracks in them must be taken out
of service (repair is not permitted).
• The clamping surfaces are free of
dirt, grease, oil and water.