Shoel NEOTEC II Gebrauchsanleitung Seite 5

E n g l i s h
Opening and Closing the Face
Cover
The face cover can be opened and closed with a
single touch. To open the face cover, pull down the
button in the bottom center of the face cover and
release the lock. Lift and rotate the face cover until
face cover can be secured in opened position by
continuing to rotate the face cover until it clicks in the
second stopper.
To close the face cover, gently rotate it downward
until you hear a click when the face cover lock
engages.
WARNING
performance, riding your motorcycle with the
face cover in fully closed position is strongly
recommended.
Do not remove the face cover from the helmet.
In case of need to adjust the face cover or the
shield/visor, consult your local SHOEI dealer
nearby.
Do not hold the button while closing the face
cover. This can cause the face cover lock to fail to
unexpectedly during riding and lead to an accident.
is locked.
face cover and check that it is locked. Carrying the
helmet with the face cover unlocked can cause
sudden opening of the face cover and the helmet
may be dropped or become damaged.
Do not open or close the face cover by grasping
F r a n ç a i s
Ouverture et Fermeture de la
mâchoire
en position ouverte en continuant de le faire tourner
jusqu'au « clic », signe de verrouillage en position
fermée.
AVERTISSEMENT
Afin de maximiser les performances de
protection pour la tête, le fait de conduire
v o t r e m o t o a v e c l e c a c h e f r o n t a l e n
position complètement fermée est vivement
recommandé.
cas de besoin d'ajustement du cache frontal
revendeur SHOEI le plus proche.
sa fermeture. Ceci pourrait empêcher le bon
qui n'est pas correctement verrouillée peut s'ouvrir
verrouillage.
Lorsque vous transportez le casque, veillez
verrouillé. Transporter le casque avec le cache
frontal déverrouillé peut provoquer une ouverture
soudaine du cache frontal et le casque peut tomber
ou s'endommager.
E n g l i s h
Chin Curtain
and wind noise into the helmet's chin area.
The chin curtain can be removed by using the
following procedure.
Removing the Chin Curtain
The chin curtain is pressed against the plate at the
pins. Refer to the drawing. Lift up the face cover plate
near its right and left pins, and remove the pins that
pass through the chin curtain plate. Pull out the chin
curtain. Remove the chin curtain on both the right
and left sides.
Installing the Chin Curtain
curtain plate in the space created. There are pins on
the interior side of the face cover plate. Insert them
chin curtain on both the right and left sides.
Pin
Projection Projection
WARNING
nearby vehicles will be reduced. Please be aware
of this while riding.
Do not pull the chin curtain with the pins in place.
If you do, the chin curtain or face cover plate may
become damaged.
Do not carry or hold the helmet by the chin curtain.
drop.
F r a n ç a i s
Mentonnière
au niveau du menton.
procédure suivante.
Extraction de la mentonnière
comme montré ci-contre. Soulevez la bordure sur les
cotés gauche et droits, et dégagez l'attache. Retirez
gauche.
Installation de la mentonnière
Comme montré sur le croquis, soulevez la bordure
AVERTISSEMENT
prendre ceci en considération lors de l'utilisation du
casque.
au préalable dégagé les attaches latérales, car
Ne pas transporter ou tenir le casque par la
le casque pourrait chuter.