Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to make perfect 90° angles with corners facing the lawn
If there are 90 degree corners that face the inside of your lawn, make wire as shown in the figure
below to help mower make perfect turns (and remove the risk that mower hits an obstacle on the
border of the lawn whilst doing this manoeuvre).
Close the loop
Once you have completed laying the wire on the perimeter of your lawn, you will arrive back to the
charging station.
• Pass the wire through the guide in the plate. Then thread the boundary wire through the bottom
of the handle.
• Cut the exceeding wire and strip the end with a pair of scissors.
• Press the red right clamp. Insert the boundary wire end into the hole above the clamp.
RED
IN
Final steps
The boring part is over! There are only a few more steps to go:
• Connect the charging station to the AC mains socket .
• If everything is fine, the LED will light green.
• If there's a trouble in the loop, such as broken wire or wire ends not properly clamped, the LED
will turn red. Check that everything is fine and see the FAQ session if the problem persists.
LED
• Open the rear of mower and insert the battery into the slot until it clicks
8
Werbung
