OSOTEK Linear 101 Benutzerhandbuch Seite 8

Lay the boundary wire around your lawn
• Use the supplied gauge to set the distance wire to edge.
• If there is a step at the edge of your lawn, keep the wire at 30 cm from it, as shown in fig 1.
• If there is no step, keep the wire at 10 cm from the edge, as shown in fig 2.
1
2
Secure the wire to the ground using pegs
• Place pegs at approximately 80 cm to each other.
• Keep the wire away from rocks or other obstacles.
• Make sure the wire is always in close touch with the ground.
Lay perimeter islands, if needed
• Protect flower beds, ponds, tree roots and other areas by surrounding them with the boundary
wire.
• Depart the edge at a right angle to reach the area to be protected.
• Surround the area with the wire, keeping 30 cm distance, until you close the island.
• Ensure that the island is at least 1 m away from other boundary wire.
• Always lay the wire clockwise. Failing to do so will make the mower drive into the island.
• Return to the edge of the lawn following the same path.
7