OSOTEK Linear 101 Benutzerhandbuch Seite 18

Environmental
influences.
Poor connection
caused by debris on
the charging strip.
When charging, the
Mower can not charging station
correctly dock suddenly loses
with the charging power. The machine
station. exits the charging
station and waits for
the power to recover.
If the charging
station power is not
restored within a few
minutes, the machine
will automatically
shut down.
The charging station
is overheating. The
display says 'E15'.
The green light
on the charging
Foreign obstacles,
station turns on
such as twigs and
before charging is
branches may be
complete.
lodged under mower.
The lawn is too wet.
The boundary wire
of another mower
or robotic mower
is positioned too
Mower runs outside
closely.
the boundary wire.
In wet conditions,
Mower does not
mow an area within the boundary wire
electric signal may
a boundary wire
zone. leak where the wire
has been joined or
Mower reverses or
rotates erratically repaired incorrectly.
near the boundary
There is boundary
wire.
wire electric signal
leakage due to
broken insulation.
Restart mower.
Clean the contact pins located
on the charging station and the
charging strip on mower using a
cloth.
Please ensure the stability of the
power supply to the charging
station.
Restart mower
Place the charging station in
a shady area or wait until the
temperature has cooled down.
Remove foreign objects from
underside of mower.
Wait until lawn has dried.
Ensure at least 1m clearance is
provided in between your boundary
wire and that of your neighbor.
Check boundary wire joints. Insulate
to provide a fully waterproof
connection.
Repair damaged boundary wire
with the wire connectors supplied.
Mower slips out
Low grip of mower
of its working area
drive wheels.
going down a hill.
Mower operative
system crashes Software or display
when charging or fault.
on standby.
Mower fails to
charge due to
over temperature
protection and is
powered off.
Mower shuts off
when docking in the
charging station.
Poor connection.
There is an obstacle
in the working area.
The cutting height is
set too low for the
length of the grass
or the grass is too
dense.
The extended
Mower stops in the
boundary wire should
working area.
not exceed 250m or
it may cause signal
problem.
The distance
between the center
of the lawn and the
boundary wire should
not exceed 20m or
it may cause signal
attenuation.
There is an inclined
Mower flips over.
obstacle on the lawn.
17
Please check the wheels are clean
and free of mud in order to have
the maximum grip possible.
Restart mower.
Place the charging station in
a shady area or wait until the
temperature has cooled down.
Check the LED light on the charging
station.
Check the connection between
the contact pins located on the
charging station and the charging
strip.
Remove the obstacle from mower's
working area.
Raise the cutting height and then
gradually lower.
Reduce the lenght of the boundary
wire.
Reduce the distance between
the center of the lawn and the
boundary wire perimeter within
20m.
Exclude the obstacle from mower's
working area.