OSOTEK Linear 101 Benutzerhandbuch Seite 13

• Mower does not cut grass like other mowers. Its cutting blades are razor sharp on two edges
and rotate in both directions for maximum cutting capacity.
• The blade turning disc makes a clockwise and counterclockwise rotation at random to use both
cutting edges and minimize the frequency of replacing the blades.
• Each cutting blade will last up to one month when it is programmed to mow every day.
• Always check to see if the blades are chipped or damaged and replace them if they are.
• When the cutting blades are dull and worn out, they should be replaced with the spare blades
provided with your mower.
WARNING!
Before cleaning, adjusting, or replacing the blades, turn your mower OFF and remove the battery.
Always wear protective gloves.
Replacing the Blades
Attention: When fitting new blades, make sure you replace ALL the blades.
• Always use new screws when fitting blades. This is important to ensure blade retention and
balance the blade turning disc. Failure to use new screws could cause serious injury.
Important:
After screwing the blade to the blade adapter, make sure the blade is able to spin freely.
1. Remove the battery and gently flip the mower over.
2. Take the screws off the blades with a screwdriver.
3. Firmly screw on the new blades.
4. Refit the battery.
12