OSOTEK Linear 101 Benutzerhandbuch Seite 16

When the mower is not stop, no manual intervention
is required.
When the mower is stop, turn power off, turn the
The bump sensor
E12 mower upside-down. Remove any obstruction, check
is bumped.
whether the mower's collision plate is normal. Turn
the mower upright, turn power on. Press START and
OK.
After trying to
escape, the
Turn power off. Take the mower inside the working
E13 mower is still
area, turn the power on. Press START and OK.
outside of its
working area.
When the mower is not stop, no manual intervention
is required.
When the mower is stop, turn power off. And take the
mower to an area free from obstacles.Turn power on.
Wheel motor
Press START and OK.
E14 is blocked in
If the error message is still displayed, turn power off.
some way.
Turn the mower upside-down and check if there's
anything preventing the wheels from rotating. Remove
any obstruction, turn the mower upright, turn power
on.
Battery charging In automatic state, no manual intervention is required.
E15
abnormality. When charging manually, try manual docking again.
The charging
station voltage In automatic state, no manual intervention is required.
E17
is wrong during When charging manually, try manual docking again.
charging.
Escaped from
E18 No manual intervention is required.
collision.
Escaping from an
E19 No manual intervention is required.
isolated island.
Escaped due to
wrong charging
E20 No manual intervention is required.
pole piece
connection.
Escaped due
to the mower
E21 No manual intervention is required.
slipping for a
long time.
Stop button
E22
pressed.
Escaped due to
E23 excessive tilt of
the mower.
The battery
power is
extremely low,
E24 or the voltage
is less than 17V
when the mower
is turned on.
Mower is outside
the boundary for
E25
more than 30
seconds.
Trapped: The
lawn mower has
been working
for more than 20
E26
minutes and has
not reached the
boundary even
once.
Notes:
• Before turning power on, always check mower is inside its working area. If not, the message
'E1' will be displayed. This message is also displayed when mower is partly but not completely
inside its working area.
• If for any reason—i.e. a party, children playing...—you want to park your mower in the charging
station: press HOME then OK. Mower will go to its station and stay there. Please note mower
will now wait until the next scheduled mowing session. If you want to re-start it at anytime,
press START then OK to start your mower.
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the
boundary wire so please refer to the installation instructions and check your set up is correct
with its help.
• If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one
of which is not provided with the charging station: when mower runs out of charge, take it
manually to the charging station.
• If mower runs abnormally once in a while, please reset it by turning it off and removing the
battery for 30 seconds, then restart it. If the problem cannot be solved, please contact our
customer service for help.
15
Press START and OK to start.
When the mower is not stop, no manual intervention
is required.
When the mower is stop, turn power off. Take the
mower to an area of your lawn free of obstacles, then
turn power on. Press START and OK.
When the mower is running normally, press the stop
button and manually dock and charge the mower.
When the mower is restarted, need to manually dock
and charge the machine or replace the high-power
battery.
Turn power off. Take the mower inside the working
area, turn the power on. Press START and OK.
Turn power off. And take the mower to an area free
from obstacles.Turn power on. Press START and OK.
If the error message is still displayed, turn power off.
Turn the mower upside-down and check if there's
anything preventing the wheels from rotating.Remove
any obstruction, turn the mower upright, turn power
on.