probst SPEEDY VS-140/200 Betriebsanleitung Seite 72

7.4 Attaching the Suction Plate
The suction plate is not included in the scope of delivery.
The operator is responsible for attaching the suction plate based on the load characteristics (surface, air-
tightness, weight).
The maximum permitted lift capacity of the suction plate determines the maximum permitted lifting
capacity of the entire lifting device (see the lift capacity plate on the suction plate).
The operator is required to document the static strength and holding force depending on the potential vacuum
and to adhere to safety factors. The standard DIN EN 13155 in its current valid version should be used as the
basis during mounting.
Probst GmbH accepts no liability for damages resulting from use of an unsuitable suction plate.
WARNING
Unexpected switching on when attaching the suction plate
Danger of injury due to vacuum.
Ensure that the vacuum generator cannot be switched on while the suction plates are being
mounted.
1. Place the lifting device on the suction plate (6).
52700015 / 52700016 / 52700019 / 52700020
Operation
23