Coltene Coltolux Led Benutzerhandbuch Seite 10

10
1.4 EN/IEC 60601-1-2:2007 sub-clause 5.2.2.2 Table 6
Recommended separation distances between portable and mobile RF communications equipment and the Coltolux
unit .
The Coltolux LED unit is intended for use in an electromagnetic environment in which radiated RF disturbances are con-
®
trolled . The customer or the user of the Coltolux
minimum distance between the portable and mobile RF communications equipment (transmitters) and the Coltolux
unit as recommended below, according to the maximum output power of the communications equipment .
Rated maximum output
power of transmitter in watts
(W)
0 .01
0 .1
1 .0
10
10
For transmitters rated at a maximum output power not listed above the recommended separation distance d in meters (m)
can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power
rating of the transmitter in watts (W) according to the transmitter manufacturer .
NOTE 1 At 80Mhz and 800MHz, the separation distance for the higher frequency range applies .
NOTE 2 These guidelines may not apply in all situations . Electromagnetic propagation is affected by absorbtion from
reflection from structures, objects and people .
LED unit can help prevent electromagnetic interference by maintaining a
®
Separation distance according to frequency of transmitter in meters (m)
150kHz to 80MHz
d = 1 .2√ P
.12
.38
1 .2
3 .8
12
80MHz to 8000Mhz
d = 1 .2√ P
.12
.38
1 .2
3 .8
12
Owner's Guide
LED
®
LED
®
800Mz to 2 .5 GHz
d = 1 .2√ P
.23
.73
2 .3
7 .3
23