Herunterladen Diese Seite drucken

TecTake 402790 Bedienungsanleitung Seite 13

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Assembling the jump mat and the frame cover
Warning: Three adults are needed to mount all springs, as is shown in Fig. 12. The springs produce a high level of tension. Be careful
that you do not pinch your fingers. Use the supplied spring clamps and gloves if necessary.
Put the jumping mat inside the frame and
attach a spring to a triangle of the
jumping mat.
Holes and
triangles in each
quarter
Attach two more springs at a 45°
angle to the already attached
springs.
Now attach any remaining springs.
Finished! Your trampoline is now
complete.
Hook the springs into the frame.
Warning: Be careful that you do not
pinch your fingers.
If a spring is under high tension,
first attach the surrounding springs
Place the frame cover over the frame,
so that all springs are covered.
To disassemble, follow the
steps listed in reverse order.
13
Holes and
triangles in
each half
Repeat this step directly opposite the spring
that has just been attached. Make sure that
there are holes and triangles between
twosprings.
Continue in this way by fitting a new spring in
the middle between each two springs. To
compensate for the tension, after each spring
change the side of the trampoline.
Attach the frame cover with black bands onto
the frame or on the legs. Do not bind them to
the springs.

Werbung

loading

Diese Anleitung auch für:

402791402792402793402794402795