Gloria MULTIBRUSH li-on PLUS Betriebsanleitung Seite 31

RZ_MULTIBRUSH_Li-on_PLUS_DE_GB_FR_NL_IT_DK_979647-03.qxp_Text_GB 25.06.24 12:02 Seite 31
13
You can regulate the speed of the
brush by pressing the speed control on
the adjustment wheel (T).
Speed recommendations for
GLORIA brushes
Position 1-2
Position 3-4
Position 5-6
14
Hold the device securely by the handle
(A) and additional handle (F) and
switch on the device. To switch ON,
firstly press and hold the lock-off but-
ton (B) for ON/OFF safety switch (E).
Then press the ON/OFF safety switch
(E) and keep it pressed.

In case of work interruptions or
danger, release the ON/OFF safety
switch (E) immediately.
7.1.1 Battery status indicator
The device is equipped with a battery
charge indicator (C) that displays the
charging status of the battery. The dis-
plays only light up when the device is
switched on.
Battery power (green LEDs):
Reserve ≤ 30%
Temperature protection
Low voltage cutoff:
NOTE!
In rare cases, after the battery has been
removed and then reinserted, the battery
status indicator (green LEDs) can display a
higher battery power than before battery
removal. The reason is that the last battery
power during operation is saved in the
device. Once the battery has been removed
and reinserted into the device, the battery
power is remeasured and a higher power
can therefore be displayed on the indicator.
soft brushes (wood brush)
harder brushes (stone brush)
joint brush (wire brush)
≤ 60% 100%
7.1.2 Battery operating time
The service life of the battery mainly
depends on the load applied to the device.
Any cleaning work performed by applying
the brush with high pressure on the surfa-
ce to be cleaned will shorten the service
life of the battery. Another factor is overly
frequent starting and stopping during
cleaning, which can also reduce battery
operating time. Handle battery and device
as described in the instructions.
7.1.3 Assembly of the brushing
tools
Figures 15 - 22
CAUTION
RISK OF BURNS CAUSED BY HOT
PARTS!
During assembly or conversion work
the drive parts of the device or compo-
nents can still be very hot and may
cause burns.
It is therefore important to observe
the following safety instructions:

Wear protective gloves during
assembly!
Disassembly of surface brush followed by
assembly of the joint brush

Switch off the device and remove the
battery (D).
15
Open the locking device (L)
the guide arm (N), as shown in
the illustration.
16
With the lock applied (L) remove the
guide arm (N) and then the surface
brush (O).
17
Now open the locking device (L)
the drive arm (Q), as shown in
the illustration and remove, with the
lock applied, (L) the drive arm (Q) with
safety guard (P).

The surface brush is now successfully
dismantled.
18
Put the guiding wheel (J), as shown in the
illustration, on the steering side of the
31
of
of