Werbung
2 Safety
2.4.2
Material damage and malfunction — MiniCODER
Material damage due to electrostatic discharge!
Electrostatic discharge can damage the electronic components of the
product.
● Only touch connector pins and connection wires while using suitable
ESD equipment .
The product is shipped in a carton with an ESD foam insert. The original
packaging protects the product from electrostatic discharge.
● Store and transport the product only in its original packaging.
Material damage due to incorrect handling of connection components!
If connectors are connected or disconnected under voltage, the product may be
damaged.
●
Only connect or disconnect connectors if the product and all connection compo-
nents are de-energized.
A wrong connection of the power supply or the output signals may damage the
product electronics.
●
Observe the connection instructions contained in these operating instructions.
Falling below minimum bending radiuses can damage cables and interrupt signal
transmissions.
●
Observe minimum bending radiuses.
Bending radiuses
–
Connection cable: Technical data MiniCODER
–
Adapter cable: Accessories
Material damage due to penetration of foreign bodies or liquids!
Foreign bodies or liquids can enter unsealed connectors and damage the product.
●
Ensure that the connectors are protected against penetration of foreign bodies
or liquids.
●
Do not use a pressure washer.
62
Possible hazards
→ page 94
→ page 96
Lenord+Bauer
GEL 2444M
Werbung
