Cleaning; Troubleshooting - Parkside Performance Prdsp 20-Li A1 Bedienungs- Und Sicherheitshinweise

˜ Troubleshooting
m
WARNING! Risk of accidental contact of spray materials with skin and eye!
Always wear appropriate personal protection equipment as instructed by the chemical
u
manufacturer when using, preparing, handling, spraying, or disposing of chemicals. This
equipment includes at least goggles, gloves, respiratory protection and protective clothing.
Before starting to work with the product, squeeze down the trigger
u
released completely. If the pressure has not been released beforehand, chemicals may splash out
in an uncontrolled manner when working with the product.
After work, carry out a test run with clean water.
u
Fault
The product can not be switched
on.
The product does not spray.
Possible cause
The battery pack is not
[ ]
inserted properly.
The battery pack is empty.
[ ]
No pressure present.
No chemicals in the spray
tank .
2 ] [
Nozzle accessories
9 ] [
spray head are blocked.
[ ]
The small filter is blocked.
[ ]
until the pressure has been
[ ]
Solution
Insert the battery pack
properly.
Charge the battery pack
Switch the power button
either I or II position to generate
pressure.
Fill the spray tank
chemicals.
Switch off the product, remove
the battery pack
the pressure.
or cone
Clean the nozzle accessories
or the cone spray head
pushing a needle through them
(see "Cleaning and care").
Switch off the product, remove
the battery pack
the pressure.
Clean the small filter
running water using a brush (see
"Cleaning and care").
[ ]
.
[ ]
to
[ ]
with
2 ] [
and release
[ ]
9 ] [
by
[ ]
and release
[ ]
under
[ ]
GB 29