Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Seite 27

˜ Cleaning and care
m
WARNING!
u
Always switch the product off, remove
the battery pack
cool down before performing inspection,
maintenance and cleaning work!
u
Only perform repairs and maintenance
work according to these instructions!
All other works must be performed by a
qualified person!
m
WARNING! Risk of chemical
exposure!
u
Always wear appropriate personal
protective equipment as instructed
by the chemical manufacturer when
using, preparing, handling, spraying, or
disposing of chemicals . This equipment
includes at least goggles, gloves,
respiratory protection and protective
clothing .
˜ Maintenance
Before and after each use, check the
o
product and accessories (e .g . nozzles) for
wear and damage . If you find any damage
(e .g . crack on the nozzle accessories
hole in the basket filter
36 ] [
filter ) , exchange them for new ones .
Observe the technical requirements
(see "Technical data") .
o Periodically check the shoulder strap
fraying . Replace the shoulder strap if it is
worn-out or frayed .
o You can order replacement nozzles, filters,
and other spare parts not listed (such
as the charger) via our service hotline
(see "Service") . Have the IAN number
available when you call the service hotline
to purchase spare parts .
18 ] [
and let the product
12 ] [
26 ] [
or small
6 ] [
˜ Repair
In case leakage is noted, it is likely that there
is a broken sealant ring near the source of
the leak . The sealant ring can wear over time,
which causes cracks and leakage . To replace
the sealant ring:
1 . Switch off the product: Press the power
[ 14 ]
button .
2 . Remove the battery pack
3 . Follow the instructions in the "Cleaning"
section to clean the parts near the leakage
area .
4 . Disassemble the product at the source of
the leak . Inspect the sealant ring for any
signs of wear or cracks .
o If a sealant ring is broken or cracked,
replace it with a matching sealant ring .
Heed the outer diameter of the sealant ring .
o After you replaced any sealant ring, fill the
[ 3 ]
spray tank
a test run to check if the leakage has been
eliminated .
Contact an authorised service centre or
o
a similarly qualified person to have the
product checked and repaired .
˜ Cleaning
m
WARNING! Risk of chemical
,
exposure!
Always wear appropriate personal protection
equipment as instructed by chemical
manufacturer when using, preparing,
handling, spraying, or disposing of
for
chemicals . This equipment includes at least
goggles, gloves, respiratory protection and
protective clothing .
[ 18 ]
.
with clean water . Carry out
GB 25