Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Seite 29

Continuous spraying without holding
down the trigger
ig. M
1. S ueeze do n the trigger
2. Push the lo k on lat h
it is in lock position.
Unlocking the trigger from continuous
spraying
1. S ueeze the trigger
2. old ba k the lo k on lat h
the trigger
[ ]
NOTE
During work breaks, do not leave
u
the product in the hot sun or near
any heat source.
Overdosing may damage plants
u
and the environment.
Underdosing may result in
unsuccessful plant treatment.
˜ Cleaning and care
WARNING!
m
Al ays s it h the produ t o ,
u
remove the battery pa k
and let the product cool down
before performing inspection,
maintenance and cleaning work!
Only perform repairs and
u
maintenance work according to
these instructions! All other works
must be performed by a ualified
person!
WARNING! Risk of chemical
m
Always wear appropriate personal
u
protective equipment as instruct-
ed by the chemical manufacturer
when using, preparing, handling,
spraying, or disposing of chemi-
cals. This equipment includes at
least goggles, gloves, respiratory
protection and protective clothing.
.
[ ]
forward so
[ ]
further down.
[ ]
under
[ ]
ig. M .
[ ]
˜ Maintenance
Before and after each use, check
o
the product and accessories (e.g.
nozzles) for wear and damage. If
you find any damage e.g. ra k on
the nozzle a essories
the basket filter
exchange them for new ones.
Observe the technical requirements
see "Te hni al data" .
Periodically check the shoulder
o
strap for fraying. Replace the
[ 6 ]
shoulder strap if it is worn-out or
frayed.
You can order replacement nozzles,
o
filters, and other spare parts not
listed (such as the charger) via our
servi e hotline see "Servi e" . ave
the IAN number available when you
call the service hotline to purchase
spare parts.
˜ Repair
In case leakage is noted, it is likely that
there is a broken sealant ring near the
source of the leak. The sealant ring can
wear over time, which causes cracks
and leakage. To replace the sealant ring:
1. S it h o the produ t Press the on
o s it h .
[ ]
2. Remove the battery pa k
3. Follow the instructions in the
"Cleaning" section to clean the parts
near the leakage area.
4. Disassemble the product at the
source of the leak. Inspect the
sealant ring for any signs of wear or
cracks.
If a sealant ring is broken or cracked,
o
replace it with a matching sealant
ring. Heed the outer diameter of the
sealant ring.
After you replaced any sealant ring,
o
fill the spray tank
water. Carry out a test run to check if
the leakage has been eliminated.
, hole in
[ ]
or small filter
[ ] [
.
[ ]
with clean
3 ] [
GB
) ,
]
27