Werbung
Never use the product in a room where there
is a danger of explosion or in the vicinity of
flammable liquids or gases.
Do not immerse the product in water or other
liquids. Do not place the product where it can
fall or be pulled into a tub or sink.
Only operate the product when it is in an
upright position.
Do not operate the product with an empty
spray tank.
It is necessary to provide the appropriate
training in safe operation.
Do not use the product while tired, ill or
under the influence of alcohol, drugs or
medicaments.
Always carry out a visual inspection before
using the product. Do not use the product if it
is damaged. If the product is damaged, have
it checked by qualified personnel.
Always check the product for leaks. If any are
found, correct them before using the product.
When assembling or removing accessories,
do not point them towards yourself or other
persons.
The product must only be operated by
1 person at a time. Nobody else must be
within a radius of 15 metres at the same time.
If there is no spray coming out from the
nozzle or the spray amount is decreased, the
hose and spray system may be blocked. Rinse
and clean all parts of the hose and spray
system (shut-off valve, small filter, nozzle pipe,
hose, nozzle) with clean water.
After the product has been stored for a long
time (e.g. during winter), fill the spray tank
with clean water. Carry out a test run to check
if there are any leakages or cracks.
Release the residual pressure in the spray
tank after each use and especially before
removing the spray tank cover. Do so by
pressing the trigger.
Do not modify the product under any
circumstance. Modifications may result in
serious injury.
All servicing and maintenance, other than
the items listed in this instruction manual,
should be performed by an authorised service
centre.
Only use spare parts and accessories
provided by the manufacturer. All other
repairs shall only be carried out by an
authorised service centre. Improper
maintenance, use of non-conforming
components and removal of safety devices
can lead to a hazardous situation, such as
death, life-threatening injuries and damage.
˜ Vibration and noise reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes and
wear personal protective equipment.
Take the following points into account to minimise
the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions.
Ensure that the product is in good condition
and well maintained.
Keep tight grip on the handles/grip surface.
[
2 ]
GB
15
Werbung
