Parkside Performance PRDSP 20-Li C2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 63

Continuous spraying without holding
down the trigger
Fig. M
1. S ueeze down the trigger
2. Push the lock on latch
it is in lock position.
Unlocking the trigger from continuous
spraying
1. S ueeze the trigger
2. Fold back the lock on latch
the trigger Fig. M .
[ ]
NOTE
During work breaks, do not leave
u
the product in the hot sun or near
any heat source.
Overdosing may damage plants
u
and the environment.
Underdosing may result in
unsuccessful plant treatment.
˜ Cleaning and care
WARNING!
m
Always switch the product o ,
u
remove the battery pack
and let the product cool down
before performing inspection,
maintenance and cleaning work!
Only perform repairs and
u
maintenance work according to
these instructions! All other works
must be performed by a ualified
person!
WARNING! Risk of chemical
m
Always wear appropriate personal
u
protective equipment as instruct-
ed by the chemical manufacturer
when using, preparing, handling,
spraying, or disposing of chemi-
cals. This equipment includes at
least goggles, gloves, respiratory
protection and protective clothing.
.
[ ]
forward so
[ ]
further down.
[ ]
under
[ ]
[ ]
˜ Maintenance
Before and after each use, check
o
the product and accessories (e.g.
nozzles) for wear and damage. If
you find any damage e.g. crack on
the nozzle accessories
the basket filter
exchange them for new ones.
Observe the technical requirements
see "Technical data" .
Periodically check the shoulder
o
strap for fraying. Replace the
6 ] [
shoulder strap if it is worn-out or
frayed.
You can order replacement nozzles,
o
filters, and other spare parts not
listed (such as the charger) via our
service hotline see "Service" . Have
the IAN number available when you
call the service hotline to purchase
spare parts.
˜ Repair
In case leakage is noted, it is likely that
there is a broken sealant ring near the
source of the leak. The sealant ring can
wear over time, which causes cracks
and leakage. To replace the sealant ring:
1. Switch o the product Press the on
o switch .
[ ]
2. Remove the battery pack
3. Follow the instructions in the
"Cleaning" section to clean the parts
near the leakage area.
4. Disassemble the product at the
source of the leak. Inspect the
sealant ring for any signs of wear or
cracks.
If a sealant ring is broken or cracked,
o
replace it with a matching sealant
ring. Heed the outer diameter of the
sealant ring.
After you replaced any sealant ring,
o
fill the spray tank
water. Carry out a test run to check if
the leakage has been eliminated.
, hole in
[ ]
or small filter
[ ] [
.
[ ]
with clean
3 ] [
GB/IE
) ,
]
61