Attaching The Plastic Nozzle Pipe; Attaching The Nozzle Accessories; Mixing The Spray Solution - Parkside Performance Prdsp 20-Li A1 Bedienungs- Und Sicherheitshinweise

˜ Attaching the plastic nozzle
pipe
Connect either end of the plastic nozzle
pipe to the shut-off valve
[ 5 ]
Push the O-ring
[
union nut towards the thread on the shut-
[ ]
off valve .
8 ] [
Turn the union nut
[
until it is tight (Fig. G).
˜ Attaching the nozzle
accessories
The nozzle accessories
only with the plastic nozzle pipe
The nozzle accessories are not to be assembled
with the stainless steel nozzle pipe
Insert the desired nozzle accessory
one end of the plastic nozzle pipe
Push the O-ring
[
the union nut towards the thread on the
[ ]
nozzle accessory
9 ] [
Turn the union nut
[
to tighten it on the thread of the nozzle
accessory (Fig. L).
[ 9 ]
.
[ 8 ]
, security ring and the
] [ ]
in a clockwise direction
]
are to be assembled
[ 9 ]
.
5 ] [
.
6 ] [
into
9 ] [
.
5 ] [
, security ring and
] [ ]
(Fig. K).
in a clockwise direction
]
Choosing the suitable nozzle accessory
Nozzle
Fan nozzle
Double head
nozzle
Single head
nozzle
Mist nozzle
NOTE
Only use the nozzles and filters supplied
u
with the product.
˜ Mixing the spray solution
m
WARNING!
Mix the chemicals strictly in accordance
u
with the manufacturer's instructions.
Incorrect mixtures may produce toxic fumes
or explosive solutions.
Risk of accidental contact of spray
u
materials with skin and eyes!
Always wear appropriate personal
protection equipment as instructed by
the chemical manufacturer when using,
preparing, handling, spraying, or disposing
of chemicals. This equipment includes at
least goggles, gloves, respiratory protection
and protective clothing.
Never spray liquid plant control chemicals
undiluted.
Application
Uniform spray
pattern
Spraying large areas
Spraying large crops
High flow rate
Spraying small areas
Spraying large crops
Spraying mist
High flow rate
GB 21