PERFECTPRO UB400R2 Bedienungsanleitung Seite 34

Automatically updating the clock
Your radio will normally update the clock automatically
using the DAB or FM signal. If no signal is available, then
you need to set the time manually. After a power failure
the radio will then set its clock the next time that you turn
on the radio in DAB or FM mode. Alternatively you may
specify that the time is not automatically updated. In this
case the clock must always be set manually after a power
interruption.
1. With your radio switched on, press and hold the Info/
Menu button to access the menu for the current mode.
2. Rotate the Tuning control knob to select "System" and
press the Tuning control knob to enter the system
settings menu.
3. Rotate the Tuning control knob to select "Time". Press
the Tuning control knob to enter the time setting menu.
4. Rotate the Tuning control knob to select "Auto update"
and press the Tuning control knob to enter the setting.
5. Rotate the Tuning control knob to choose an update
option from "Update from Any" "Update from DAB"
"Update from FM" or "No update" as required. Press the
Tuning control knob to confirm your choice.
Note:
If you select "Update from Any", "Update from DAB",
"Update from FM" the current time received will be
displayed. If no signal is found you should either position
the radio or its aerial so that a signal can be received, or
revert to manual clock mode.
33