Operating Your Radio - Fm; Manual Tuning - Fm - Perfectpro Ub400R2 Bedienungsanleitung

Operating your radio – FM
1. Straighten the antenna properly above the radio. Press
the Power On/Off button to switch on your radio.
2. Press the Source button to select FM waveband.
3. To scan up in frequency, first rotate the Tuning control
knob in a clockwise direction and then press the
Tuning control knob. Your radio will scan in an upwards
direction (low frequency to high frequency) and stop
automatically when it finds a station of sufficient
strength. To scan down in frequency, first rotate the
Tuning control knob in a anti-clockwise direction and
then press the Tuning control knob. Your radio will
scan in a downwards direction and stop automatically
when it finds a station of sufficient strength. After a few
seconds the display will update. The display will show
the frequency of the signal found. If the signal is strong
enough and there is RDS data present then the radio
will display the station name.
4. When the waveband end is reached, your radio will
recommence tuning from the opposite waveband end.
5. Adjust the Volume control to the required setting.
6. To switch off your radio, press the Power On/Off button.
Manual tuning – FM
1. Press the Power On/Off button to switch on your radio.
2. Press the Source button to select FM waveband.
3. Rotate the Tuning control knob to tune to a station. The
frequency will change in steps of 50 kHz. When the
waveband end is reached, the radio will recommence
tuning from the opposite waveband end.
4. Adjust the Volume control to the required setting. To
switch off your radio, press the Power On/Off button.
GB
20