Integration Of Video Door Module In Abus Nvr - Abus Moduvis Bedienungsanleitung

In general, the following cameras are not compatible with MODUVIS due to multi-stream
technology, resolution, or camera platform:
- ABUS fisheye cameras
- ABUS 180-degree panoramic cameras
- ABUS thermal cameras
- TVIP91xxx TVIP92xxx IPCA64xxx, IPCA62510 and IPCA72510 series cameras
- All camera models that do not have network port 8000.

9.14 Integration of video door module in ABUS NVR

The video image of the video door module can also be integrated into an ABUS NVR
(NVR100x0 series, TVVR36xx1).
The video is captured via the RTSP protocol, which only enables continuous display or
continuous recording (no motion detection or other event recording types).
Please observe the data protection regulations prevailing at the installation
location!
The following steps are necessary for integration:
1. Creation of a user-defined protocol in the camera management of the ABUS NVR.
2. The followingstream details must be used:
Protocol:
Transfer Protocol:
Port:
Stream path:
3. When a new channel is added to the NVR, this user-defined protocol is then selected for
the video door module.
The username ("admin") and password are usually the same as the door station monitor.
If the password has been changed via the CMS software, this changed password must
be used.
NOTE: For the ABUS network recorder NVR100x1 series to be released in Q3 2024, normal
integration via IP address and port 8000 (i.e. like a normal IP camera) is possible. This
means that the motion detection of the door video module can be used without restriction.
RTSP
Automatic
554 (default port)
Streaming/Channels/101(Main Str
Streaming/Channels/102 (Sub Stream)
142
)