Abus Cms: Perform Firmware Update Of The - Abus Moduvis Bedienungsanleitung

9.10 ABUS CMS: Perform firmware update of the Moduvis components
Caution: Never disconnect the power supply or the network cable during an upgrade
Attention: Only carry out the update in a stable network environment (LAN).
It is recommended to reset each device to factory settings after a firmware update.
The ABUS CMS software is required to install a firmware update on a monitor (TVHS21210).
Connect the devices to the network and open the remote configuration of the respective
devices.
Go to "Maintenance" / "System Maintenance" and select the appropriate file for the device.
A door video module (TVHS21010(S)) can also be updated via the direct web interface.
The current firmware version can be found for the respective product/model on abus.com in
the download area.
fter a firmware update,
1. Restart the entire system
2. reset all updated devices to factory settings ("Restore all")
the following steps must be carried out:
by removing the supply voltage
138