Abus Cms: Extended Setting Options - Abus Moduvis Bedienungsanleitung

9.11

ABUS CMS: Extended setting options

The following is a brief overview of the setting options via remote configuration with the
ABUS CMS software for the TVHS21210 monitor.
Each monitor and each door video module appears as an independent network device in the
network. It does not matter whether the device is connected via 2-wire or PoE.
The remote configuration in the CMS for the TVHS21010(S) video door module opens the
web interface, similar to current ABUS network cameras or NVR/DVRs. This can be used for
quick and easy configuration.
The video door module has a web interface. For further details, please download the
instructions for the TVHS21010 web interface from abus.com.
Remote configuration " Monitor TVHS21010 ".
Note: Many of these functions can also be configured directly on the monitor.
Device Information such as "Firmware", "Serial
information number" etc.
General Device name and device ID (not relevant
for door intercom system)
Time Settings for date/time, daylight saving time
and NTP server
System Maintenance menu for firmware update,
maintenance setting factory settings and device restart
Users Not used
RS485 Not used
ID Selection of the apartment number (flat
configuration number) in the "Indoor Station" operating
mode (main monitor)
In "Station Extension" mode (extension
monitor), the extension monitor number is
configured.
Note: The selection of the operating mode
"Main monitor" or "Extension monitor" and
the assignment of the numbers is usually
done via the menu of the respective
monitors themselves. (e.g. in the set-up
process via the installation wizard)
Time Settings for call duration, live image
parameters display duration, call forwarding delay,
ringing tone duration.
Note: These settings can also be changed
directly in the monitor menu.
139
Intercom" section