Installation Of Side Entrances; Setting Up Extended Bell Buttons For Multi - Abus Moduvis Bedienungsanleitung

9.2

Installation of side entrances

If you would like to integrate another door video module (maximum 16) into the system in
order to realise a secondary entrance (e.g. goods receipt, cellar door, etc.), please read the
required chapter in the web interface instructions for the door module under "Setting up
secondary entrances".
9.3 Setting up extended bell buttons for multi-party houses
The additional extension modules (TVHS20020(S)) can be used to realise up to 49 bell
buttons for multi-party houses. The extension module is connected to the main video module
via a connection cable.
If only one additional bell button module is used, the installation can be carried out without
the ABUS CMS software / web interface.
The main door module is the doorbell with the "Apartment number 1" by default. The
TVHS20020(S) extension module is automatically set to apartment number 2 - 7. The "flat"
here corresponds to one independent flat.
The bell buttons are customised / assigned in the "Intercom" / "Press button to call" menu.
The respective bell extension module is configured here in the "Submodule" selection box
and the bell buttons are assigned to the respective flat.
For further information, please refer to the web interface instructions for the door module.
Alternatively, the buttons can also be configured directly on the local monitor interface of the
TVHS21210 monitor.
To do this, assign bell buttons to apartments/apartments directly in the Monior in the "Call
button settings" menu. (The configuration page is located in the door station configuration,
which can be accessed via the "cogwheel" settings icon.
129