PeakTech 2005 Bedienungsanleitung Seite 34

* Do not operate the meter before the cabinet has been
closed and screwed safely as terminal can carry voltage.
* Do not store the meter in a place of explosive,
inflammable substances.
* Do not modify the equipment in any way.
* Do not place the equipment face-down on any table or
work bench to prevent damaging the controls at the
front.
Opening the equipment and service – and repair work
*
must only be performed by qualified service personnel
Measuring instruments don't belong to children
*
hands.
CAUTION!
Note on using the supplied safety test leads according
the IEC / EN 61010-031:2008:
Measurements in the field of overvoltage category CAT I or
CAT II can be performed with test leads without sleeves with
a maximum of up to 18mm long, touchable metallic probe,
whereas for measurements in the field of overvoltage
category CAT III or CAT IV test leads with put on sleeves,
printed with CAT III and CAT IV must be used, and therefore
the touchable and conductive part of the probes have only
max. 4 mm of length.
Cleaning the cabinet
Clean only with a damp, soft cloth and a commercially
available mild household cleanser. Ensure that no water
gets inside the equipment to prevent possible shorts and
damage to the equipment.
-33-