PeakTech 2005 Bedienungsanleitung Seite 32

* Do not use this instrument for high-energy industrial
installation measurement.
* Do not place the equipment on damp or wet surfaces.
* Do not exceed the maximum permissible input ratings
(danger of serious injury and/or destruction of the
equipment).
* The meter is designed to withstand the stated max
voltages. If it is not possible to exclude without that
impulses, transients, disturbance or for other reasons,
these voltages are exceeded a suitable presale (10:1)
must be used.
* Replace a defective fuse only with a fuse of the original
rating. Never short-circuit fuse or fuse holding.
* Disconnect test leads or probe from the measuring
circuit before switching modes or functions.
* Do not conduct voltage measurements with the test
leads connected to the mA/A- and COM-terminal of the
equipment.
* The 10A-range is protected. To avoid damage or injury,
use the meter only in circuits limited by fuse or circuit
breaker to 10A or 2000VA.
* To avoid electric shock, disconnect power to the unit
under test and discharge all capacitors before taking any
resistance measurements.
* Do not conduct current measurements with the leads
connected to the V/-terminals of the equipment.
* Check test leads and probes for faulty insulation or bare
wires before connection to the equipment.
* To avoid electric shock, do not operate this product in
wet or damp conditions. Conduct measuring
only in dry clothing and rubber shoes, i. e. on isolating
mats.
-31-
works