Werbung
Gulnara • Aviso 20250
Tools
The basic tools you will need to build and finish the models are:
1. A modelling knife - preferably with an assortment of different shaped insertable blades and a Stanley knife
which is ideal for tapering the planking strips.
2. A razor saw - for cutting the larger planks and dowels.
3. Small pliers - for bending brass and copper wire and also to help push in pins for the planking.
4. A range of twist drills from 0.5 - 3 mm and a pin vice.
5. A David plane- for chamfering planks and shaping the masts and yards.
6. A selection of different profile needle files: flat, round, half round, triangular etc.
7. Tweezers.
Abrasive paper
You will need a sanding block and different grades of glass paper, from coarse to fine, working down
through the grades until the desired finish is attained.
Adhesives
1. White PVA (Evostick Resin W) is the main wood adhesive that is required, but remember that the total cure
time is about 24 hours.
2. Super glue for dissimilar materials, and also it can be used to stiffen the ends of rigging, making it easier
to pull through the blocks and dead eyes.
3. Epoxy resin is the best for the permanent fitting if the stem quarter galleries and figurehead, and also the
brass funnel to the boiler.
4. Contact or impact adhesive - this is an alternative for the second planking of the hull instead of PVA and
pins.
Paint and Varnish
You will need „matt black" Humbrol no. 33, „satin black" Humbrol no. 35, „oak" Humbrol no.94 and „gold"
Humbrol no.16. Good quality matt wood varnish and walnut wood dye.
Safety
Always work in good lighting conditions, and a well ventilated room. When you are sanding down, it is
advisable to wear a mask, sanding the hull especially produces a lot of dust.
Note - Changes
The parts no: 69 - engine room, 70 - engine room, 157 - Decline, 178 - boiler, 191 - skylight, 198 - Decline
No longer lie in part as a solid form, but are composed of milled parts. The position of the parts can be
found on the enclosed sheet.
Klaus Krick Modelltechnik • Postfach 11 3 8 • D-75 4 34 Knittlingen
Telefon 0 70 43 / 9 35 10 • Telefax 0 70 43 / 3 18 38 • www.krick-modell.de
Werbung
