Dometic POWER & CONTROL CAM360AHDHD Montage- Und Bedienungsanleitung Seite 36

2. Use the SHIFT
or
3. If neccesary, use the
4. If necessary, repeat step
5. Use the Set Time button to save the set time.
Setting the GPS Time Synchronization
Activate or deactivate the time synchronization via the GPS.
ON: The automatic configuration of the time is activated.
OFF: The automatic configuration of the time is deactivated.
Set the time zone using the UTC dropdown menu.
Adjusting the Daylight Saving Time Setup
Activate or deactivate the automatic adjustment to daylight saving time via the Switch buttons.
ON: The automatic daylight saving time adjustment has been activated.
OFF: The automatic daylight saving time adjustment has been deactivated.
Set the daylight saving time range display using the Mode buttons.
The format of the daylight saving time start and end setting changes.
Week: The displayed time is "month-day-week-hour-minute".
Date: The displayed time is "month-day-hour-minute".
Use the and
the daylight saving time via the Offset button.
The Offset time changes in half hour steps.
Use the corresponding dropdown menus to set the start and end time for the daylight saving time (see
Using the dropdown menus
10.10 Calibrating the camera system
WARNING! Health hazard
Ensure that all areas around the vehicle are displayed by the video system. Blind spots pose a safety
risk.
NOTE
• Avoid strong shadows on the calibration mats.
• Ensure uniform illumination, preferably in daylight.
• 2 calibration mat must be fully visible in each camera. Use the 4 fisheye views shown for ori-
entation.
1. Attach the calibration mats at each corner of the vehicle.
36
button on the remote control to switch to the next time unit.
button on the remote control to move to the previous time unit.
1 on page 35 to 3 on page 36.
buttons on the remote control or the keyboard to set the offset time change of
on page 33).