Initial Operation; Operation Notes - Scheppach HS730 Originalbetriebsanleitung

Initial operation

Before commissioning observe the safety notes.
• All safety and auxiliary installations must be fitted.
• Check the rocker inlet for wear and replace it if nec-
essary.
• Check the rocker that it returns to its home position
autonomously.
• Check the saw blade for perfect fitting and correct
direction of rotation.
• Changeover, setting, measuring and cleaning op-
erations are only to be conducted with the motor
switched off. Pull the mains plug and wait for the
rotating tool to come to halt.
• The saw is constructed solely for the cross cutting
of firewood.
• Regardless of the diameter of the wood only one
work piece is to be put on the rocker.
• ATTENTION! Do not saw faggots or multiple pieces
at once.
• Put curved wood on the rocker in such a way that the
curved-out side is directed to the saw blade.
• Ensure the machine is securely placed on solid
ground.

Operation notes

ON/OFF switch (16) fig. 2
The machine is equipped with a safety switch preventing
the machine from being activated after a voltage drop.
Turning on
Press green button I
Turning off
Press red button O
m
Attention! The motor hums during and shortly after
the braking time. The switch must never be operated
during this phase. The motor may only be switched on
again after the humming sound has stopped.
Rotational dlrectlon of the saw blade Fig. 6
Ensure that the rotational direction of the saw blade is
the same as the rotaional direction given on the guard.
You can change the direction by placing a screw dri-
ver in the slot provided in the plug collar and adjust the
correct direction by moving to the left or right applying
slight pressure.
Sawing
1. Turn on the machine.
2. Wait until the saw blade has reached full speed.
3. Put the wood on the rocker.
4. Take hold of both handle bars of the rocker with both
hands and lead it evenly to the saw blade; thus the
saw blade is revealed.
23