Scheppach HS730 Originalbetriebsanleitung Seite 29

• Check all safety installations after each maintenance
and cleaning activities.
• Ensure that there are no tools or other materials on
or in the machine before putting it into operation.
• Remove possible sawdust blockages at the dis-
charge.
Change of saw blades Fig. 7-11
m
Remove the mains plug before changing the saw
blade.
m
Danger of cutting! The saw blade is massive and it
could be to slick.
Wear gloves when replacing the saw blade.
• Do not use any saw blades made of HSS steel.
• Do not use any cracked saw blades or such that
have changed their shape.
• Only use well-sharpened saw blades.
m
Danger of burning! The saw blade is still hot shortly
after cutting.
Change of saw blades
1. Pull out the spring cotter pin (fig. 7, A). When doing
so, firmly hold the tilt table.
2. Slowly lower the tilt table towards the ground.
3. Use the locking pin (fig. 8, A) to secure the saw
blade against turning.
4. Loosen the screw (fig. 9, A).
5. Remove the washer (fig. 9, B), the front saw blade
flange (fig. 9, C) and the saw blade (fig. 9, D).
6. Clean the saw blade flanges
7. Install a new or sharpened saw blade.
Pay attention to the correct running direction of the saw
blade: The arrow on the safety guard and the arrow on
the saw blade must show to the same direction.
8. Reinstall the front saw blade flange and the washer
9. Secure the saw blade using the screw.
10. Slide the both washers on the support pin
(fig. 10, A).
11. Lift the tilt table and guide the support pin into the
hole (fig. 10, B).
12. Install the cover plate (fig. 11, A) in its guide at the
same time.
A second person may be required.
13. Plug the spring cotter pins through the support pin
(fig. 10, A).
14. Remove the locking pin (fig. 8, A).
Replacing the plastics insert
Immediately replace the worn or damaged plastics in-
serts (fig. 1, 13).
1. Loosen the screws of the plastics insert and remove
them.
2. Insert a new plastic insert and screw it tightly in
place.
29