Troubleshooting; Technical Data; Disposal - Cleanmaxx Z 09671 Gebrauchsanleitung

EN

Troubleshooting

Should your device stop working at any time, exhibit signs of damage or require a spare
part, please contact the customer service department. For your own safety, do not
attempt to carry out repairs yourself. The following table contains tips on how you can
remedy small problems yourself:
Problem
The device generates
no suction.
Low suction force.
Dust escapes from the
device during cleaning.
Unusual odour

Technical Data

Model number:
Article number:
Voltage supply:
Output:
Protection class:

Disposal

The packaging can be recycled. Please dispose of it in an environmentally
friendly manner and take it to a recycling centre.
Dispose of the device in an environmentally friendly manner. Dispose of it at a
recycling centre for used electrical and electronic devices. You can obtain more
information from your local authorities.
26
Possible cause / solution
Ensure that the plug is correctly inserted into the plug
socket.
• Is the exhaust air valve in the handle open? Close it.
• Adjust the suction strength on the suction strength
control.
• Is the dust container full (MAX marking reached)? Empty
the dust container.
• Is one of the fi lters heavily soiled? Clean it.
• Is the nozzle, the telescopic tube or the suction hose
clogged? Pull out the mains plug and clear the clogging.
• Is the dust fi lter seated correctly in the dust container?
Is the dust container closed correctly and inserted in the
device? Is the dust container cover closed correctly?
Correct this if necessary.
• Is one of the fi lters heavily soiled? Clean it.
A new odour is normal when the device is used for the
fi rst time; it disappears after a while.
CP-CY4207ES-2
Z 09671
220–240 V~ 50 Hz
1400 W
II
Customer service
importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
*) Calls subject to a charge.
All rights reserved.
/