Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start-up
How to configure the minimum number of characters that must be different com-
pared with the previous password when changing the password:
1. Press the
Ctrl+Num
2. Select the
System setup
3. Select the
Password Complexity
4. Select the
Min. different
5. Enter the desired minimum number of characters that must be differnt compared
with the previous password (Default: 0 or 8 with activated SecureCert-Feature)
NOTE:
The minimum number of different characters compared with the previ-
ous password must not be higher than the minimum password length.
6. Press
to save your settings.
F2
Configuring the login options
To improve security, further configuration options are available in the login options
area.
You can specify how many failed attempts are accepted when entering a password
and how long a user is locked out after exceeding the maximum number of failed
attempts.
In this area, you can also specify how many simultaneous superuser sessions are
permitted.
How to set the maximum number of failed password entry attempts:
1. Press the
Ctrl+Num
2. Select the
System setup
3. Select the
Login options
4. Select the
Max. failed attempts
5. Enter the desired maximum number of failed attempts when entering the pass-
word (Default: 0 = off/unlimited number of failed attempts or. 3 with activated
SecureCert-Feature, max. 1,000)
6. Press
to save your settings.
F2
34 · G&D VisionXS-IP-F-TypeC-UHR
(default) hotkey to open the OSD.
entry and press
line and press
line and press
Enter
(default) hotkey to open the OSD.
entry and press
line and press
Enter
line and press
.
Enter
Enter
.
.
Enter
.
.
Enter
.
Werbung
