Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Connecting keyboard and mouse of consoles and other devices
Keyb./Mouse:
Connect the mouse and/or the keyboard of the console to this interface.
In the default settings, you can connect additional USB input
USB Devices:
devices,USB mass storage devices, and/or a supported display or tablet to this inter-
faces.
Activate the
generic USB
mode on page 104) if you want to connect another USB input device or USB mass
storage device. In this mode, any data of the USB device is not altered when transmitted
to the computer module.
IMPORTANT:
If the
keyboard connected to the
IMPORTANT:
This product allows simultaneous use of up to five GenericUSB
devices via a console module. For this, both the used console module and the
used computer module must support the use of up to five GenericUSB devices.
Only up to three HighSpeed devices (e.g. USB flash drive) and two FullSpeed
devices can be used. If additional HighSpeed devices are connected, they will not
be accepted.
NOTE:
There are three
hub or a USB composite device to connect four or five generic USB devices.
The two
Keyb./Mouse
NOTE:
The USB Type-C interface, which is primarily used to output video data,
also offers the option of accepting USB K/M data. This means that a USB key-
board and USB mouse can be connected to a USB hub on a monitor.
Type-C/DP Out/USB K/M:
24 · G&D VisionXS-IP-F-TypeC-UHR
mode (see (De)Activating an USB keyboard or the »Generic USB«
generic USB
mode is active, the OSD cannot be operated by a
USB Devices
Generic
interfaces on the console module. You need a USB
interfaces cannot be used for
Connect the console monitor
sockets.
generic USB
mode.
Werbung
