Scheppach DP60 Original Bedienungsanleitung Seite 33

- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
15. Troubleshooting
Fault
Device does not start
Heavy vibrations
Motor overheats easily
Motor makes excessive
noise
Possible cause
Motor, cable or plug defective,
building circuit breaker tripped
On/off switch (11/10) defective
Motor defective
Base plate (1) not fastened in place
Drill bit not clamped centrally
Overloading of the motor, insuffi-
cient cooling of the motor
Coils damaged, motor defective
www.scheppach.com
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal
of waste electrical and electronic equipment.
Remedy
Check power outlet, mains connection
cable, mains plug. Have repair carried out
by electrical specialist. Check building
circuit breakers.
Repair by customer service department
Repair by customer service department
Secure machine to a work bench or similar
Check drill bit in chuck (14)
Avoid overloading the motor while drilling,
remove dust from the motor in order to
ensure optimal cooling of the motor.
Have checked by customer service
department
GB | 33