Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LIGHTING AND ITS REPLACEMENT
When the door of refrigerating chamber opens, the LED light turns on.
When the lighting is damaged, please remove the lampshade first and then
replace the LED lighting.
The specific operations are shown in the following diagram:
1.Please move the lampshade and the thermostat out 3-5mm in the direction of
the arrow.
2.Take out the lamp shade and thermostat downwards the arrow.
3.Pull the connection terminal, use the screwdriver to remove the LED light
board and replace it.
Note: If the LED lamp is abnormal, it should be
replaced by professionals. Do not take dismantling
and replace it privately in order to avoid damage.
NON-FAULT PHENOMENON
The heating of both sides of the cabinet and the frame around the door of
freezing chamber: The heating will be obvious in start-up operation and
summer. This is the normal work of the refrigerator, and there is no effect on
the food in the cabinet.
Long-term operation of compressor: When the refrigerator is first used, it takes
a long time to work to reduce the temperature to a set value, and the
compressor will run intermittently after the stable operation of refrigerator.
Surface heating when the compressor is running: When the compressor works
normally, the surface temperature is high, which is a normal phenomenon. Do
not touch it with your hands.
58
Werbung
