Hitachi RCI-1.0FSR1 Installations- Und Betriebshandbuch Seite 23

◆ Sensing area for the motion sensor kit PS-MSK2 (optional) only as an accessory
for air panel P-N23NA2
The sensing area for the motion sensor is shown in the figure below when applying the motion
sensor with the air panel.

NOTE
The motion sensor may detect as absence in the case that the indoor unit with the motion sensor is
installed to a high ceiling (higher than 4m) even if someone is in a room.
PMEN0649 rev.0 - 03/2023
Motion sensor
INSTALLATION HEIGHT OF INDOOR
UNIT H (M)
SENSING AREA FOR MOTION SEN-
SOR ØA (M)
MOTION DETECTION
Ø a
From floor surface 0.8m
2.7 3.2
Approx. Approx.
7.0 8.8
Human Motion
h
3
19