Hitachi RCI-1.0FSR1 Installations- Und Betriebshandbuch Seite 22

◆ For ceiling already completed with panels
Attach this side of the scale to the inner side of the opening of the ceiling
Attach this side of the scale
to the outer side of the unit
opening at each side of the unit
◆ Ceiling not completed with panels yet
• Tighten the nuts of the suspension brackets after the adjustment is completed. Apply LOCK-
TIGHT paint to the bolts and nuts in order to prevent them from loosening. If not done,
abnormal noises or sounds may occur and the indoor unit may come loose.
PMEN0649 rev.0 - 03/2023
Indoor Unit
Checking Scale
Check the dimension of
Pattern paper for installation
Dimension for opening
Suspension bolt
Surface of Ceiling
Pattern Board for Installation
Attach this side of the scale to the lower side of the unit
Indoor Unit
Ceiling
panel
Checking Scale
Check the height of the ceiling at
Dimension for opening
Unit
Screw (M6)
Attach this side of the
scale to the ceiling Panel
each corner of the unit
3
18