Hitachi RCI-1.0FSR1 Installations- Und Betriebshandbuch Seite 21

◆ Mounting of Indoor Unit
• Mount the nuts and the washers to the suspension bolts. Put the washer so that the surface
with insulation faces downwards as shown below:
Suspension bracket (attached indoor unit)
• Consider piping connection side before lifting indoor unit.
• Lift the indoor unit by hoist, and do not put any force on the drain pan.
• Secure the indoor unit using the nuts and washers.

NOTE
• If a false ceiling has already been installed, complete all piping and wiring work inside the ceiling
before hooking-up the indoor unit.
• Secure the indoor unit using the nuts, and flat washers.
◆ Adjusting of space between indoor units and false ceiling opening
• Adjust the indoor unit to the correct position while checking with the pattern for installation.
PMEN0649 rev.0 - 03/2023
Suspension bolts (field-supplied)
Nut (field-supplied)
Washer with insulation (accessory)
Washer (accessory)
Nut (field-supplied)
Suspension bolt
Suspension bracket
Drain pan
Checking Scale for Dimension of Opening
Surface of ceiling
Pattern Board for Installation
Packing (Corrugated Board)
(mm)
3
17